Download Print this page

Advertisement

Quick Links

Advertisement

loading
Need help?

Need help?

Do you have a question about the 35008 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Flying Gadgets 35008

  • Page 2 Transmitter LI-Po Batteries Screwdrivers Lower fusealge motor unit 3 x Propellors...
  • Page 3 Install the battery with the correct polarity, when the red LED lights up on the aeroplane then close the battery cover.
  • Page 4 Connect the red & blue push rods magnetic connectors between the upper fuselage and lower fuselage motor unit.Then connect the fuselage magnetic connectors.
  • Page 5 Frequency indicator light Press the Throttle stick, then turn on the transmitter. The buzzer will ring 3 times, that means the transmitter is selecting a frequency. During this time the blue LED on the controller will be on as it searches for the reciever.
  • Page 6 When connecting the aeroplane and transmitter, remember to switch on the transmitter first and then the aeroplane battery. To stop interference when connecting more than one aeroplane make sure you only connect one at a time. The connection of the aeroplane and the transmitter should take only 5 second.
  • Page 7 The transmitter will beep when the batteries in it are low, replace them ASAP. Depending on the model you are flying, make sure that the servo switch is in the correct position.
  • Page 9 Everytime you connect the upper fuselage and lower fuselage motor unit you need to check the elevator. The elevator should be aligned with he horizontal stabilizer. If not you can adjust the elevator by using the trimmer buttons on the left of the transmitter (See Pic).
  • Page 10 Every time you connect the upper and lower fuselages together you need to check the rudder and elavons. The rudder should be in line with the vertical stabilizer. The elavons should be in line with the trailing edge of the wing and parallel to the horizontal stabilizer.
  • Page 11 Unscrew the motor, the gently remove the propellor as shown in the photo and then replace with a new propellor. Propellor not working The aeroplane is spinning or Aircraft not balanced crashes on take off. Take off in to the wind Not taking off towards the wind Can not take off Not enough speed...
  • Page 12 2. If you crash the model and need spare parts you can purchase them from your local dealer or direct from Flying Gadgets Ltd. 3. We reserve the right to change the content or parts without notice.