Jenx Monkey Instructions For Use Manual page 4

Prone standing system
Hide thumbs Also See for Monkey:
Table of Contents

Advertisement

General Information
Important Safety Info
This product must be thoroughly inspected by a qualified person at least annually
Ensure that your Therapist has confirmed that the product is correctly set up, by signing the 'Set
Up' section of the Log book before using this product. If the product has not been set up by your
Therapist DO NOT USE.
Jenx Limited recommends that children are never left unattended whilst using this Medical
Device. Children may slip or fall when unattended and may suffer serious injury. It is the sole
responsibility of the person caring for a child using this Medical Device to ensure the safety of the
child in the Device should they be left alone.
Always read the instructions before operating. Failure to read and follow the Instruction for Use,
especially with regard to moving parts, may pose a risk to the user.
Do not use this product if you suspect or know that it is broken or faulty. Please contact Jenx
Limited immediately for advice: Jenx Limited, Tel: +44 (0)114 285 3376.
This product contains small parts which could present a choking hazard to small children.
All Jenx Limited products are tested to meet current Fire Safety regulations. Always keep
products away from; naked flames, cigarettes and sources of heat such as heaters.
Jenx Limited supplies the necessary tools to adjust each product. These tools are supplied for
use by trained therapists only. Store the tools in a safe place and keep away from children.
Assemble product fully before use. Please contact Jenx Limited if you have any problems at this
stage. Jenx Limited, Tel: +44 (0)114 285 3376.
Ensure that good care is taken of your product: clean regularly. Do not use abrasive cleaners.
When not in use, store this product in a dry place that is not subject to extreme temperatures.
Places not to store this product include garages, attics or garden sheds.
All belts and harnesses should be used at all times. For therapy purposes it may be necessary
to deviate from this rule and any deviation should be fully documented as part of a Risk
Assessment or Therapy Program and all relevant staff and carers appropriately trained. Secure
client with straps before adjusting product. Ensure finger's width between safety strap and client
to prevent over tightening or client moving to inappropriate position. Adjust straps for each client
and changes of clothing. Minimum Velcro® overlap: 3 inches (7.5cm) on all straps. If strap is not
long enough: DO NOT USE PRODUCT.
This product conforms to the European Medical Devices Directive. It has not been tested in
conjunction with other manufacturer's products. Do not add any accessories other than Jenx
Limited accessories to this product. If in doubt, contact Jenx for advice +44 (0)114 285 3376.
Any changes or alterations carried out by persons other than a Jenx authorised service person
will invalidate the warranty and Jenx can accept no liability for any injury or damage so caused.
All Jenx products are Medical Devices and are sold on the understanding that they will be
prescribed, issued and maintained in line with current national device management guidelines.
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents