Baumr-AG FUJI-MICRO F5200Ri User Manual page 16

Fuel-Injected Petrol Powered Inverter Generators
To change the engine oil:
1. Place the machine on a suitable work surface that is flat and level
and have a container ready to catch drained oil.
2. Remove the 2 screws (rotate left) securing the engine access cover,
and remove the cover.
3. Clean the machine around the oil filler so that no dirt or other
material enters the engine when the cap is removed.
4. Unscrew (rotate left) and remove the oil filler.
5. Insert the supplied oil drain tube (D) to the oil filler hole and screw it
in (rotate right).
6. Tilt the machine and drain all oil from the engine. Once drained,
allow the machine to sit level again.
7. Fill the supplied oil fill bottle (E) with approximately 0.45l of engine
oil, then insert the nozzle into the oil filler and carefully add oil to the
engine until the permissible maximum is reached. Double- check
the oil level (described above).
8. When finished, reinstall (rotate right) the oil filler cap until firm. Wipe
off any residual oil from the machine.
9. Re-install the engine access cover and secure it with the 2 screws (rotate right).
16
D
E