Peavey Automix 80304050 Owner's Manual page 8

REMOTE VOLUME (22)
The master level of the mixer can be controlled remotely with a simple connection on the back of the unit. A
10 K to 100 K potentiometer can be wired as shown in the drawing below. A 10 K pot will provide approxi-
mately 0 to 25 dB of attenuation. A 100 K pot will provide 0 to 45 dB of attenuation. If desired, a control
voltage can be inserted to command 0 to 70 dB of attenuation. The internal gain trim must be set full CW to
achieve the maximum attenuation range of the remote volume.
NOTE: The control voltage should never exceed 13 volts DC.
LINK PORT (23)
To increase the number of inputs available, multiple Peavey Automix's can be linked together. Linking
automixers is a very simple process. It can be done with a small flathead screwdriver and a length of two
conductor shielded wire.
a. Using the small screwdriver, remove the factory installed jumper wires in the link port from the slave
unit.
b. Connect the mixers with the shielded wire as shown.
figure 4 Remote Volume
figure 5 Link Port
figure 6 Link Port
remove » »
remove »
»
SHIELD
8