Status Output - Peavey Automix 80304050 Owner's Manual

MUTE (18)
Channels can be muted individually by shorting this terminal to ground. It provides approximately 45 dB of
attenuation.

STATUS OUTPUT (19)

The status is a DC logic output that is low (0 volts) when the channel is active and high (3.8 volts) when the
channel is not active. This DC voltage can be used to key video cameras or trigger key lights on active
microphones.
LOOP (Channels 1 and 2) (20)
This is a signal loop that allows an external device such as an EQ to be inserted into the signal path of the
first two channels. When used without external processing these loops are hardwired.
MUTEBUS (21)
The Mutebus is a control port that when shorted to ground will mute all channels that are assigned to the
mutebus (approximately 45 dB). The channels to be muted must be attached to the mutebus using the
internal switch marked OFF/MBUS. (See number 7).
figure 1 Mute
figure 2 Loop
figure 3 Mutebus
CEQ 280
IN OUT
7