Table of Contents
Advertisement
ActiveSync Connection
ActiveSync Connection
2. ActiveSync Safety Information
1) When starting for the first time
a. Remove the Active Sync program which has been previously installed.
b. Install new Active Sync. If 'Get Connected' dialogue appears while installing, press 'Cancel' button.
C, After a completion of installation, select 'Connection Settings' menu below the File in the Active Sync
2)
When "Unknown device" dialogue pops up on the PC, after a detection of USB.
a.
With the terminal plugged into the cradle, turn on the terminal.
b. Disconnect the terminal from the cradle and then re-plug it.
3).
When a message "Connecting..." lasted for long at the Active Sync
a.
Remove the terminal from the cradle to disconnect them.
b. Bring up the 'Connection Settings' dialogue from File Menu. Uncheck 'Allow USB connection with this
c. Bring up 'Connection Settings' dialogue again and check 'Allow USB connection with this desktop
d. Connect the terminal to the cradle again. Then, Active Sync operates properly.
BIP-5000
menu. Check 'Allow USB connection with this desktop computer' checkbox and make sure "Status :
USB is available" message appears. If 'Get Connected' dialogue pops up this time, mis-operated
USB driver still exists. Bring up
from 'Windows CE USB Devices'.
desktop computer' checkbox and then click 'OK'.
computer' check box and then click 'OK'.
'Control Panel→System→ Device
Manager' to remove an error device
Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
Advertisement
Table of Contents
