Orcam myeye User Manual page 47

OrCam User Guide Version 7
Safety
Before using the OrCam device, read the following precautions carefully to avoid dangerous
situations and to ensure ideal performance of your OrCam device. Handle your OrCam
device with care. It can be damaged if dropped, burned, punctured, or crushed. Do not open
the Head or Base Units.
The OrCam device is designed to work in ambient temperatures between 32° and 104° F (0°
and 40° C) and in normal conditions (Relative Humidity of 10% to 90% RH and Atmospheric
Pressure of up to 2000m above sea level (700hPa)). The device can be damaged if used
outside of this range. Store and transport in a cool, dry place (32° to 104° F (0° to 40° C) and
Relative Humidity of 5% to 90% and atmospheric pressure of 700hPa to 1060hPa)).
The OrCam device is water resistant but not waterproof. This means that the Head Unit can
withstand light rain or drizzle for short periods of time, although it is not recommended, as
long as the Base Unit is covered and protected. Do not use the OrCam device in heavy rain,
when at the beach or swimming pool, or in or near a bathtub or shower. Do not submerge
the OrCam device in any type of liquid. IP Code: IP22.
Do not expose the device to chemicals, such as household cleaners, aerosol sprays, solvents,
alcohol, or ammonia. If you experience an allergic reaction to any of the elements of the
OrCam device contact a medical professional.
There is a cord connecting the Head and Base Units. Do not disconnect this cord from either
the Head or Base Unit unless specifically instructed by an OrCam representative. Do not pull
on the cord or cut it in any way.
Should you have a problem operating the OrCam device and believe there is something
wrong with the device, do not attempt to repair it by yourself. Only qualified OrCam
personnel may repair or service your device. Unauthorized repairs may void your warranty.
Do not attempt to replace the battery; you may damage it, which could cause overheating
and even injury. The battery is designed to last for three years of average use (three charging
cycles per week on average) after which it may need to be replaced. Use only the AC adapter
supplied with your OrCam device. Using another AC adapter may void your warranty and
could cause severe injury.
Do not force a connector into a port or apply excessive pressure to a button. This may cause
damage that is not covered under the warranty. If a connector does not insert easily, check
for obstructions in the port and verify that you have the correct connector for that port. Do
not combine with software, hardware, or other equipment not supplied by OrCam
Ensure that the rubber cover on the bottom of the Base Unit is closed whenever the
connectors are not in use. Exposing the Base Unit to magnetic fields may damage the unit or
erase your data.
When you are using the OrCam device or charging the battery, it is normal for the Base Unit
to get warm. If the unit becomes excessively hot, leaks, or gives off a burning smell, turn the
device off immediately and contact OrCam support.
46
Page