Orcam myeye User Manual page 25

OrCam User Guide Version 7
Let's try again. Please point at the center of product three times. For example,
hold once at arm's length, once closer, and then once against a different
background.
The OrCam device has successfully started learning a new product. Move and/or
rotate the product to change the background and point again. The OrCam device
takes up to three pictures per side.
No product detected. Cancelling product learning.
The OrCam device was not successful in learning the new product and has
terminated product learning. Make sure that each time your point you hear the
double-beep and the camera shutter sound.
Did not learn this side.
The OrCam device did not recognize the additional side of the product. If no
additional product sides are needed, proceed in recording the product name.
Done with this side. You may point three times at another side of the product
or stop now.
The OrCam device has successfully "learned" one side of the new product. To
continue with an additional side, turn the product and point again. To complete the
process, remove the product from view.
Please name the product after the beep.
Record product name after the beep. Speak clearly and loudly for the best result.
Press button to confirm adding the product, or press volume button to record
again.
Press the trigger button to confirm the recording and adding of the product or re-
record the product name by pushing the volume button.
Cancelling learning.
Product learning cancelled when trigger button is pressed during the learning
process or when confirmation is requested and no button is pressed.
24
Page