Safety Warnings; Installation Instructions - Marmitek WD861 Proguard 800 Series User Manual

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in
normally dry spaces. Do not expose the transmitter to rain or moisture.
• Do not expose the components of your systems to extremely high temperatures
or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• The product should only be repaired or serviced by a qualified repairman.
• Keep batteries out of the reach of children. Dispose of batteries as chemical
waste. Never use old and new batteries or different types of batteries together.
Remove the batteries when you are not using the system for a longer period of
time. Check the polarity (+/-) of the batteries when inserting them in the product.
Wrong positioning can cause an explosion.
• Automatic switching devices provide comfort, but can also be dangerous. They
can surprise people or can ignite clothing hanging over an electric heat source.
Please be careful and take appropriate measures to avoid accidents.
INTRODUCTION
The WD861 is an indoor flood sensor and transmitter designed for use with
Marmitek's ProGuard800 supervised wireless range of receivers. When you wish to
know more about the complete system, its possibilities and its settings, then you
can check out the installation manual or visit www.nicoshop.com .
This unit is intended for installation adjacent to water tanks, piping, radiators and
anywhere prone to damage caused by an undetected water leak. In the event of
flooding or leakage, the WD861 notifies the control panel 30 seconds after
detecting the presence of water.

INSTALLATION INSTRUCTIONS

1. To open the transmitter's housing, insert a small screwdriver at the bottom of
the unit between the front and back cover and twist the screwdriver to release
the cover.
2. Remove the divider separating the battery from the contacts on the battery
holder. When you apply power and the Tamper switch is open, the WD861
enters Test mode during which a transmission is sent every few seconds. You
can terminate Test mode by closing the Tamper switch. Test mode is
automatically terminated after approximately five minutes.
Note: Due to the occurrence of voltage delay in lithium batteries that have
been in storage, the batteries may initially appear to be dead. In this case,
leave the unit in Test mode for a few minutes until the battery voltage
level is stabilized.
WD861 2