Table of Contents
Advertisement
Remote Control Preparation
Installing the batteries in the remote control
1 .
Press down on the retaining catch on the lid of the battery recess on
the remote control and remove the lid by sliding towards the end.
2.
Insert two AAA batteries into the recess, checking that the batteries are
installed with the correct polarity, + away from the spring
tensioners.
3.
Replace the lid over the recess and gently push the lid
forward until it snaps firmly into place.
Caution
1.
Keep batteries out of children's reach.
2.
Don't attempt to recharge, short-circuit, disassemble, heat or
throw the batteries into the fire.
3.
Always replace both batteries at the same time. Never mix new and old
batteries or batteries of a different type.
4.
If you don't intend to use the remote controller for an extended period,
remove the batteries to prevent possible leakage, corrosion and
damage to the remote.
5.
Do not drop, apply shock or step on the remote control.
6.
Do not spill water on the remote control.
Note:
If the receiver does not respond when operating the remote control from a close
range, you will need to replace the batteries.
Using the Remote Control
1.
To use the remote control, point it towards the front of the PVR.
2.
The remote control has a range of up to 7 metres from the set top box
at an angle of up to 60 degrees.
3.
The remote control will not operate if its path is blocked.
Note:
Sunlight or very bright light will decrease the sensitivity of the remote control.
After Sales Support
TEL: 1300 766 659
10
Advertisement
Table of Contents
