Bartscher 100048 Translation Of The Original Instruction Manual page 11

Soup keetle
Table of Contents

Advertisement

Pour 2.0 litres of water (up to the „MAX" marking) into the external pot. Do not pour
more than 2.0 litres of water, otherwise some will spill over when the insert pot is
placed inside.
NOTE!
Shorten heating time by pouring warm water, cold water takes longer to heat up.
CAUTION!
Never turn the soup kettle on with an empty external pot.
Prepare the desired dishes and place the warm (hot) food in the insert pot. Place the
insert pot through the carrying rim. Hold the carrying rim and place the insert pot into
the external pot.
Place the lid on the soup kettle.
First, connect the power cord to the device's socket, then insert the plug into a single
grounded socket.
Turn the device on using the ON/OFF switch located on the rear wall.
Set the appropriate temperature for the dish to be heated. The yellow heating control
light will come on.
The adjustable temperature dial allows for heating of
water in the external pot at regular intervals. The yellow
heating control light comes on during the heating phase.
When the set temperature is reached the control light
goes off, and it comes on again when the
temperature in the external pot falls.
Heating time depends on the volume and temperature of food and of water in the
external pot.
Open the lid to serve food as desired.
After serving food, close the lid again to avoid heat loss.
When finished using the device, set the temperature dial all the way to the left by
turning it counter-clockwise and remove the device's plug from its socket.
The unit is equipped with a function protecting against operating while dry. If the
unit is accidentally turned on without water or with too little water in the internal pot,
the protection function is activated and the unit automatically shuts off.
The red control light for protection against operating while dry will come on.
If this happens, turn the unit off via the ON/OFF switch located on the rear wall of the
unit and wait for it to cool. After it has cooled, fresh water can be poured in and the
unit can be used normally.
- 22 -

Advertisement

Table of Contents
loading

Table of Contents