Table of Contents
Advertisement
HD MotionCam Installation Manual
Note: If the IP address is not listed, the computer used for access is most
likely not connected to the same subnet as the camera and the testing will
need to be finished in another location where the computer and camera
are on the same subnet. If the camera is connected to the same subnet as
the computer and the camera is installed properly, the local network may
not assign DHCP IP addresses. The camera will need to be connected to
a switch that is also connected to the computer in order to set a Static IP
address. Please refer to the section titled, "Setting a Static IP Address for
your HD MotionCam" on page 22.
6. Double click the address to pull up the configuration and operation controls
for the camera. The Device address may also be directly typed into an address
bar of an Internet Explorer browser.
IMPORTANT: Internet Explorer must be installed on the computer used for
attempting to view the live video.
EN.PM.UM24 20160211
-15-
Page 15 of 29
Advertisement
Table of Contents
