Installing The Monitor - Waeco PerfectView M511L Installation & Operating Manual

_RV-511S.book Seite 27 Mittwoch, 15. März 2006 3:08 15
PerfectView M511L
To make and test the electrical connection, the following tools are required:
Diode test lamp (1 1, page 3) or voltmeter (1 2, page 3)
Insulating tape
Heat shrinking sleeve
Hot air blower (1 10, page 3)
Crimping tool (1 11, page 3)
Soldering iron, if required (1 12, page 3)
Solder, if required (1 13, page 3)
Cable bushing sleeves, if necessary
To fasten the cables, you may require additional cable binders.
6.2

Installing the monitor

Warning
Select the location of the monitor so that it cannot injure anybody in the vehicle
under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor (6,
page 5 and 7, page 5).
Never install the monitor in areas where your head may impact or in the area that would
be filled by an expanding airbag. This could cause injury if the airbag opens.
The monitor may not impair your vision when driving (8, page 5).
The installation location should be flat.
Check that there is sufficient room underneath the installation location to attach the
washers and nuts.
Check beforehand that there is sufficient room for the drill head to come out on the
other side.
Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
Ensure that you can lay the connection cables to the monitor.
To perform the installation, proceed as follows:
➤
Push the monitor (c 1, page 5) onto the mounting plate of the monitor
bracket (c 2, page 5) and secure it on the monitor bracket with the knurled screw
(c 3, page 5).
➤
Position the monitor and the attached monitor bracket for testing.
➤
Mark the outlines of the corners of the monitor bracket (c 2, page 5) on
the dashboard.
➤ Unscrew the monitor from the monitor holder.
Mounting the LCD monitor
27