System Configuration - AITONS EKTC07-1G Owner's Manual

AITONS EQUIPMENT

SYSTEM CONFIGURATION

VENTILATION CONTROL
The ventilation control lever is located at left side of unit,
behind front panel.
NOTE: The vent door shipping hardware must be removed
before using vent control lever. See Installation Instructions.
When set at CLOSE, only the air inside the room is circulated
When set at OPEN, some outdoor air will be drawn into room.
Energy Tip:Keep the vent control at CLOSE. Room air will
ADJUSTING AIR DIRECTION
To adjust air direction from outward (default) to upward:
1. Remove front panel. See Fig. 7.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 13.
3. Turn louver insert and rotate 180°. See Fig. 14.
4. Replace louver insert.
5. Replace screws and front panel.
Fig. 13—Backside of Front Panel
OWNER'S MANUAL
Fig. 14—Adjusting Louvers
Fig. 12—Ventilaiton Control Location
10
Packaged Terminal A/C