Operating Time Related Inspections; After The First 5 Operating Hours; After The First 25 Operating Hours; Every 25 Operating Hours - LIMBACH L 2000 EA Operating And Maintenance Manual

7.3

Operating Time related Inspections

After 5 Operating hours
After 25 Operating hours

Every 25 Operating hours

Every 50 Operating hours

Every 100 Operating hours
Every 250 Operating hours
Every 500 Operating hours

7.3.1 After the first 5 Operating hours


Check valve clearance, replace cylinder head cover gasket as necessary.

7.3.2 After the first 25 Operating hours


Work as specified in Chapter 7.3.4
7.3.3 Every 25 Operating hours

Grease magneto couplings. Applicable to all engines except L 2000 EA, DA.
7.3.4 Every 50 Operating hours

Check fuel and lubrication system.

Clean engine.

Check crankcase ventilation.

Clean induction air filter or replace, if necessary.

Change engine oil, clean oil screen.

Check valve clearance, replace cylinder head cover gasket as necessary.

Check compression.

Clean and check spark plugs (see section 8.14).

Check drive belt tension.

Check and grease throttle pushrods and bowden cables.

Check oil level of Stromberg-Zenith carburetors..

Grease magneto couplings (except L 2000 EA, DA).

Check harness.

Check bolts, nuts, safety pins, and engine mounting frame for tight fit and proper condition.

Perform engine test run. (see section 8.20).
Edition: 01.03.2016
Operating Manual L 2000
section
7.3.1 7.3.3 7.3.4
X
X
7.3.5 7.3.6
X
X
X X
X X
X X X
7.3.7
X
Page: 26/48