Maintenenance Schedule; Daily Check; Periodical Checks; Every 6 Months Following 100 H Inspection - LIMBACH L 2000 EA Operating And Maintenance Manual

Maintenenance Schedule

7
Maintenance at Limbach aircraft engines is to be performed after fixed time periods or when
reaching a certain interval of operating hours. In addition, a "daily check" has to be performed
before each flight.
Repair activities during engine maintenance may only be performed by authorized persons.
7.1

Daily Check


Remove engine cowling.

Check bolted connections.

Check baffle assembly.

Check harness.

Check condition of drive belt.

Check cowling for cracks and correct attachment.

Check clearance of throttle pushrods and bowden cables.

Check engine oil level and refill as necessary.
Volume difference between max. and min. markings: 1 l.

Check oil and fuel system for leakage.

Perform test run (see section 8.20).
7.2

Periodical Checks

7.2.1 Every 6 Months Following 100 h Inspection

Check carburetor diaphragm of the Stromberg-Zenith carburetor for brittleness, strain or
cracks and replace, if necessary.

7.2.2 Every 2 Years after the last Overhaul

Disassemble and check magneto and replace as necessary (SLICK Magnetos only).

7.2.3 Every 5 Years after New or Main Overhaul

Replace oil and fuel hoses (mounted to the engine).
The oil and fuel hoses mounted to the engine are signed with a lapse date,
e.g. 5.15 - i.e. to be replaced not later than May 2015.
Edition: 01.03.2016
Operating Manual L 2000
Page: 25/48