Ignition - LIMBACH L 2000 EA Operating And Maintenance Manual

Possible Cause:
Carburetor float defective.
Carburetor diaphragm defective.
Lack of damping oil in carburetor.
Wrong idling speed.
Throttle does not open fully.
Carburetors not synchronous (2-carburetor
system).
Wrong installation of carburetor gasket (at air
filter).
Choke engaged at warm engine.
Choke defective (worn out).
Wrong mixture setting.
Carburetor icing.
Induction air filter badly contaminated or
blocked.
Induction system leakage.
Wrong fuel.

12.2.2 Ignition

Possible Cause:
Magneto defective.
Wrong magneto timing.
Ignition switch defective.
Ignition harness loose or defective.
Spark plug defective.
Wrong spark plugs.
Edition: 01.03.2016
Operating Manual L 2000
Remedy:
Replace float.
Replace diaphragm.
Refill damping oil.
Adjust idling speed.
Repair throttle control.
Adjust carburetor setting.
Replace gasket, consider notches.
Disengage choke.
Repair or replace choke.
Check setting and operation of carburetor
and correct as necessary.
Operate carburetor heating system.
Clean or replace air filter.
Seal or replace induction system.
Refill fuel tank with specified fuel.
Remedy:
Repair or replace magneto.
Check and set magneto timing as
necessary.
Check grounding wire and switch and replace
as necessary.
Fasten or replace harness.
Replace spark plug.
Use specified spark plugs.
Page: 46/48