Chapter 2
Initial Installation
This Chapter covers the software installation of the iCamera.
Requirements
•
Network cable. Use standard 10/100BaseT network (UTP) cable with RJ45 connector.
Procedure
1. Choose an Installation Site
Select a suitable place to install the iCamera.
2. Disassemble the Mount kit
Disassemble the mount kit in order to connect the LAN cable.
1. Take out the wall-mount kit from package box.
2. Remove Knob.
3. Use a screwdriver to loosen the screw in order to remove the top cover.
3. Connect LAN Cable
1. Connect LAN cable through the hole.
2. Lock the front cover into wall-mount kit.
3. Put the Knob back.
4. Use LAN cable to connect the device to the Ethernet port on the iCamera.
Note! For the first installation, the user needs to ask the professional's assistance
to connect the iCamera and iHub-3001B via the Y-cable (with Ethernet). After the 1
installation is completed, the user will use the Y-cable (without Ethernet) only.
2
st
4