Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Patton electronics OnSite 9100
Summary of Contents for Patton electronics OnSite 9100
-
Page 1: Expansion Modules
OnSite Models 9100, 9130, 9200 & 9300 Expansion Modules Quick Start Guide Part Number: 07M9000-QS, Rev. B Revised: February 20, 2012 Sales Office: +1 (301) 975-1000 Technical Support: +1 (301) 975-1007 E-mail: support@patton.com WWW: www.patton.com... -
Page 2: Unpacking And Installation
Read the safety information in the OnSite Series User Manual and Administrator’s Reference Guide thoroughly before installing and operat- ing your OS-10 Series system. Failure to follow this safety information WARNING can lead to personal injury or damage to the equipment. This guide provides instructions for adding expansion modules to your Patton OnSite base system. -
Page 3: Cable Management
2.2 Cable Management The HD-E1 module uses a future bus connector on the front panel and requires the use of cables with compatible plugs for access to the E1 signals. These cables are ordered separately from the module and need to be specified according to the termination option for the module (75-ohm or 120-ohm) and the required cable length for the site. -
Page 4: Getting Started
2.3 Getting Started After the module is securely installed to the chassis (using the mounted screws on the front panel), turn the power back on to the S1000 system. The STAT LED of the HD-E1 module turns on to a solid amber light for about ten seconds after the system detects the module during the reboot process. - Page 5 3.2 Getting Started The 3-port DS3/E3 module supports insertion into or removal from any available expansion slot on the modular OS1052 and OS1063 chassis while the system is powered on and carrying traffic. The following procedure applies to module insertion into a system after the power is turned ON: After the module is securely installed to the chassis (using the mounted screws on the front panel), the STATED •...
- Page 6 4.2 Getting Started The HD-ENET module supports insertion into or removal from any available expansion slot on the OS1052 and OS1063 chassis while the system is powered on and carrying traffic. The following procedure applies to module insertion into a system that is powered ON: After the module is securely installed to the chassis (using the mounted screws on the front panel), the STAT •...
- Page 7 5.1 Unpacking and Installation To install the 2-port STM-1 module, follow the procedures in Chapter 10 of the OnSite Series Administrator’s Ref- erence Guide. Figure 1 shows the alignment and insertion of the module into one of the available expansion slots of a modular OS-10 Series platform.
-
Page 8: Additional Information
6.0 Additional Information For detailed instructions, refer to the OnSite Series User Manual and the OnSite Series Administrator’s Reference Guide available online at www.patton.com/manuals/OS10xx.pdf and www.patton.com/manuals/ OS10xx-arg.pdf. A.0 Customer and Technical Support Online support: www.patton.com E-mail support: support@patton.com—answered within 1 business day Telephone support: Standard: +1 (301) 975-1007 (USA), Monday–Friday: 8:00 am to 5:00 pm EST (1300 to •...