Attaching The Seat; Standard Adjustment Seat; Quick Adjustment Seat; Knob Adjustment Seat - MTD 13AM762F765 Operator's Manual

Attaching The Seat
1 Seatstyles vary bytractormodeland thereare three
I rj <¢ d fferentsty es ava abe
[ Standard Ad ostment
QuickAdiustment&
Setti nqUp • Knob Adius ment
,_ If theseat for yourtractordid notcome attached,refer,to
YO U [' Lawr_ Figure4, Figure5, and Figure6 to kJentifyyourtractors
seat styleand followthe applicableinstructionsbelowto
attachit,
Before operat ng this
machine, make sure
theseat e"gaged
t,eseat stop; stand
behind the machin e
and pull back on seat
sons, seats are either
fastened to the tractor
backward to the pivot
models so equipped)
i •
Figure 4
NOTE:Forshippingreasons,seatsare eitherfastened
to the tractorseat'spivot bracketwith a plastictie, or
mountedbackwardto the pivot bracket,In eithercase,
freethe seat form its shippingpositionand removethe
two hex screws(or knobs,on modelsso equipped)from
the bottomof seat beforeproceedingwith applicable
instructionsbelow,
Standard Adjustment Seat
1, Positionthe shoulderscrews (foundon the baseof the
seat) insidethe slot openingsin the seat pivot bracket,
Figure4,
2, Slide theseat slightlyrearwardin the seat pivot
bracket,lining up the rear slots in the pivot bracket
with the remainingtwo holesin the seat'sbase,
3, Selectdesiredpositionforthe seat,and securewith
the two hexscrewsremovedearlier,SeeFigure4,
Quick Adjustment Seat
NOTE:If yourseat wasshippedmountedbackwardson
the seatpivot bracket,pull outthe tab foundon the seat
stop and hold it open whileslidingthe seat off the seat
pivot bracket,See Figure5,
Figure 5
1, Line up the plasticseatspacerswith the slotsin seat
pivot bracket,
2, Slide seat in until frontseat spacerengagesthe seat
stop,See Figure5,
WARNING: Before operating this
machine, make sure the seat is
engaged in the seat stop, stand
behind the machine and putl back
on seat until fully engaged into
stop.
Knob Adjustment Seat
1, Positionthe shoulderscrews (foundon the baseof the
seat) insidethe slot openingsin the seat pivot bracket,
Figure6,
2, Slide theseat slightlyrearwardin the seat pivot
bracket,lining up the rear slots in the pivot bracket
with the remainingtwo holesin the seat'sbase,
3, Selectdesiredpositionforthe seat,and securewith
10