Selecting A Programme With A Coin Unit In Use; Delay Start - Miele W 6073 (MC 23) Operating Instructions Manual

Additional functions
Programmable functions
It is possible to programme additional
functions or change programme sequences.
See Programme changes.
Any changes to the standard machine
version must be noted on the Programme
change chart in this booklet as a record for
any subsequent servicing work. This is of
particular importance for the service
technician, when electronic units may need
to be exchanged.
Coin operating mechanism / coin unit
Selecting a programme with a coin
unit in use
^ Open the on-site stopcock(s). Switch on
the on-site mains switch.
^ Select a programme and temperature.
m "Starching", w ""No final spin" and
d "Delay start" are not available with coin
operation.
^ Add detergent and fabric conditioner.
^ Insert coins/tokens.
^ Press the " h Start" button.
Coin unit C 5002, C 5003, C 4060
Coins or tokens are "lost" if any of the
following are done after the coins have been
inserted but before the " h Start" button has
been pressed:
– the machine door is opened,
– the programme selector has been turned
past " r End" to another programme.
– a programme is interrupted for more than
20 seconds with the coin time counter.
Note for the supervisor:
Coins and tokens should be emptied on a
regular basis to ensure the coin box does
not get jammed full.
18

Delay Start

After the drum door has been shut and a
programme chosen the "m min" light flashes
as a reminder of the "Delay start" option.
With the "d Delay start" button a delay of up
to 9 hours 30 minutes can be pre-selected,
in 30 minute steps, and beyond this in
one-hour steps up to 24 hours.
After the delay start time has been set, press
the "h Start" button to confirm the
command. The time display counts down
showing how many hours and minutes it is
until the programme starts automatically.
"Delay start" can be cancelled before the
"h Start" button has been pressed by
turning the programme selector to "r End".
At the end of the delay period the
programme starts and the "m min" indicator
light goes out. The "Time min." /
"Temperature o C" display shows the water
temperature until the drain valve opens at
the end of the Main wash. From this moment
to the end of the programme the time left is
shown.
M.-Nr. 06 006 842