Mig - LORCH MX 350 EU Operation Manual

LORCH
12 Start-up
51
~--=~~:=;;---__,,
50
~~======:=::-~
49 ~,......,...=:~~fk,
Start-up
38 39 40 41 42 43
~
46
+ -
45
Fig. 8:
Control penel MX 350
30
The Fault LED
~ ights
up continuously, and the
38
The Synergy LED light sup if the Synergy function
fault code is displayed in the 7 segment display
is selected.
35.
39 The MIX LED lights up if MIG welding operating
31
The Remote control LED lights up when a remote mode with mixed gas is selected.
control is connected.
40
The C0
2
LED lights up if MIG welding operating
Control knob 48 specifies the maximum value for
mode with C0
2
is selected.
the control range of the remote control. If 1 OOA
41
The TIG LED lights up if TIG operating mode is
has been set, for example, 1 OA - 1 OOA can be
called up using the remote control.
selected.
Lights up when wire feed case (case type lnt) is
42
Electrode LED
connected
lights up if Electrode operating mode is selected.
32
LEDVRD
43
Electrode CEL LED
lights up continuously with active VRD function
lights up with operating mode Electrode CEL
(reduction in idle running voltage) flashes if the
selected (Electrodes with cellulose-containing
output voltage exceeds the value permitted by
encapsulation, suitable for vertical downward
the standard (e.g. in welding mode or if operating
welding)
mode MSG welding LED 39,
40
selected)
flashes if gouging operating mode selected.
33
The Seconds LED lights up when a value is dis-
44
welding process selector switch
played in the 7 segment display 35 in sec.
serves for selecting the TIG operating mode,
34
The % LED lights up when a value is displayed in
MIG welding with mixing gas
the 7 segment display 35 in percent.
MIG welding with C0
2
•
MMA or CEL electrode.
35
7-Segment-Display
If you hold the button down for longer than 2
indicates the selected power level , weld voltage
sees., if the MIG (MIX/CO, ) operating mode has
or wire feed speed.
been selected, the Synergy operating mode is
If the secondary parameters are activated, the
switched on (LED Synergy 38 lights up).
code and the set value are shown alternately.
If you hold the button down for longer than 2
36
Welding voltage LED lights up when the welding sees., if the Electrode (MMA/CEL) operating
voltage is displayed in the 7 segment display 35 mode has been selected , the gouging opera!-
in volts. ing mode is switched on (LED Electrode CEL 43
37
The Welding current LED lights up when the
flashes).
welding current is displayed in the 7 segment
45
Polarity indication
display 35 in amps.
46
Polarity indication
-10 ·
10.13