Furuno MFD8 Installation Manual page 22

10.At the Output Sentences field, check the NMEA0183 sentences to output.
Name
AAM Waypoint arrival alarm
APB Autopilot sentence
BOD Bearing origin to destination
BWC/BWR Bearing and distance to waypoint
DBT Depth below transducer
GGA GPS fix data
GLL Geographic position (L/L)
GTD Geographical Position, Loran-C TDs ZDA
HDT Heading true
MTW Water temperature
Note: If the Pilot mode is chosen to Zeus (at step 7), check APB, RMC, and XTE.
11.At the Sensor Type field, check sensor data that is input to the MFD.
Example 1: Check Position & SOG/COG for GPS receiver connection.
Example 2: Check Heading for heading sensor connection.
When using the DATA2 and/or DATA3 ports on the MFD, set the NMEA0183 port 2 and/or port
3.
12.If the GPS receiver GP-320B is connected, click the [Advanced Setup] button to show the set-
ting menu for GP-320B. Set all items referring to the table shown below.
NMEA0183 Output sentences
Meaning
15
Name
RMA Loran-C data
RMB
RMC GPS/Transit
VHW Speed/heading (through water)
VTG Speed over ground, course (true)
WPL Waypoint location
XTE Cross-track error, measured
Time and date
ZTG UTC and time to destination waypoint
att Heading/Roll/Pitch
Meaning
Basic Setup