Furuno MFD8 Installation Manual page 15

How to connect cables to DVI-D, VIDEO, AUDIO or USB ports
The above-mentioned ports are behind the connector cover on the rear panel. Access to the ports
and connect cables as shown in the procedure below. There are two methods, i.e., for waterproof-
ing or non-waterproofing.
For waterproofing
This method requires the optional connector boot (Type: OP19-7, Code No.: 001-028-090).
Name
Boot cover 19-028-3141
Fixing metal 19-028-3142
Rubber stopper 19-028-3143
Cable tie CV-150B
Binding screw M3x10
1. Unfasten four binding screws to remove the connector cover at the rear of the display unit.
Discard binding screws.
Binding screw
(4 pcs.)
2. Pass DVI-D, VIDEO, AUDIO and/or USB cables through the fixing metal (supplied).
Contents of OP19-7
Type Code No.
100-342-642-10
100-342-650-10
100-342-660-10
000-167-183-10
000-162-662-10
Connector cover
Qty
1
1
1
1
4
Fixing metal
8