Table of Contents
Advertisement
INSTALLATION
Remoxe and discard tile cantilever shelf packing clips
_
K
located just above each shelf where it hooks onto the
fralne. To remove the plastic clips, wiggle the clips side-
TURN CLOCKWISE
TO
ways
and
pull
straight
out.
RAISE
CABINET
CORNER
Locating
Your
Refrigerator
1. Allow a free flow of air through the front base grille.
'2. Your model should not be installed where the room
TURN
temperature
will go below 55 degrees F., because it
COUNTER-
CLOCKWISE
TO
will not run frequently enough to maintain proper
LOWER
CABINET
texnperature in the freezer.
CORNER
3. For ease of installation, you should ]ea_e a space of
about 1/2 inch between the refrigerator and adjacent
3. it is not necessacv to lock the refrigerator in place.
However, if that is desirable, ttn_l one or both of the
}
walls or cabinets. If the refrigerator is placed with the
locking feet clockwise. They are located near the
hinge side against a wall, you may want to leave addi-
tional space so the door can he opened wider. (Refer
/_'ont wheels.
to the installation
instruetlons
for more detail.)
If the floor is not level and it is neeessa D to raise the
_"
rear of the cabinet, we suggest rolling the rear wheels
Important
Leveling
Information
onto a piece of pl?_voud or other shim iuaterial.
Your refrigerator is equipped with f_contand back rollers
4. To replace, center the clips in the cut-out areas and
so it can be moved away from the wall tor cleaning. The
push in until the base grille snaps iuto place.
}}controllers are adjustable and should be positioned so
the refrigerator sits firmly on the floor and is level.
Connecting
the Appliance
WARNING:
This appliance is designed to operate
To
adjust
the
front
rollers:
on a nominal 115 volt, 15 amp, 60 cycle line. There
1. Remove the base grille by grasping the ends, lift and
should be a separate, grounded circuit setMng this
pull out.
appliance only. Do not use an extension cord.
This appliance
is equipped
with a three-pronged
J_
grounding plug for your protection against possible elec-
trical shock hazards. It must be phlggcd into a ground-
ing receptacle. Where a standard two-prnng wall recep-
tacle is encountered,
it is the personal responsibility and
obligation of the customer to hme it rq)laced with a
_
_
properly grounded three-prong wall receptacle. Do nut
under
any circumstances,
cut or remoxe tile third
2. To level the refrigerator, nse a screwdriver and turn
(ground) prong fi'om the power cord. Do not use an
roller adjusting screws eloe!avise to raise the cabinet
adapter plug.
or connterclockavise to lower the cabinet.
PAGE 1
Advertisement
Table of Contents
