Battery Information And Installation - Sportline hydracoach User Manual

At the same time, the Impeller Assembly will also disengage
from the short Connector Tube and the Upper Cap.
To replace the Impeller Assembly with Tubing, simply reverse
this process. Make sure that both of the rails are aligned
properly so that the Impeller Assembly's locking tabs engage
the notches in the Upper Cap. Gently push the Impeller
Assembly up and into the short Connector Tube and the
Upper Cap making sure that the barbed fi tting is securely
inserted within. At this point, you should hear an audible
"click" indicating that the Impeller Assembly with Tubing
is properly attached to the Upper Cap.
IMPELLER ASSEMBLY AND TUBING
Both the Short Connector Tube and the Longer Draw
Tube that attach to either end of the Impeller Housing may
be removed and then reattached by simply pulling them
off and pushing them back on to the barbed fi ttings.
Note: The Impeller Housing and Tubes can only fi t together
in one orientation or the system will not work. Please make
sure that the Short Connector Tube is at the top of the
Impeller Housing (defi ned by the check valve inside) and the
Longer Draw Tube is at the bottom.
MOUTHPIECE AND UPPER CAP ASSEMBLY
To remove the Mouthpiece, grasp it fi rmly and
pull until it comes free of the Upper Cap.
To replace the Mouthpiece, simply press it over
and down on to the stem of the Upper Cap until
it is properly seated.
BEZEL WITH COMPUTER AND BPA-FREE BOTTLE
With the Upper Cap removed from the Bottle,
the Bezel with attached Computer may be lifted up
and off the Bottle as a single piece. To replace,
simply reverse the process and press the Bezel with
Computer back down and onto the Bottle.
6
COMPUTER AND BEZEL
The Computer detaches from the Bezel by
means of a tab and notch system. Simply
pinch both sides of the Bezel inward while
gently pressing on the Computer's face, and
the Computer will come free from the Bezel.
Note: The Computer only fi ts within the Bezel from the rear and
in one orientation. To replace the Computer, simply place it into
the back of the Bezel and press until you feel the locking tabs
of the Bezel engage the notches in the Computer.
Battery
Information and Installation
The HydraCoach computer comes with a CR2032 3V Lithium
Battery installed. To activate for the fi rst time, unscrew
the battery door clockwise on the back of the computer
and remove the battery tab/fi lm.
Ensure the battery remains in
place (+ Side Up). Replace the
battery door, and rotate
counter-clockwise to tighten.
The computer should now be
activated and ready for Setup.
ON/OFF FEATURE
To ensure the battery retains its life, the HydraCoach has a
manual On/Off feature. If you plan to not use the bottle for a
couple days and do not want to drain the battery, press and
hold the "MODE" button for 2-3 seconds to turn OFF the
computer; Press and hold the "MODE" to turn the computer
back ON.
IMPORTANT NOTE
• See User Guide to locate battery case. Battery tab must be
removed before initial use.
• Peel off protective LCD sticker and discard.
7