Save Battery (Savebat): Menu 36; Scan (Scan): Menus 37, 38, And 39 - JETStream jt270m User Manual

When using the programming software, you must specify both
receive and transmit frequencies directly.

Save Battery (SaveBat): Menu 36

Battery Save mode lowers current consumption by
putting the receiver in a low power "sleep" mode
periodically during quiet periods with no received
signals. Set Menu 36 ON to enable this function, or
OFF to disable it. The default setting is ON.

Scan (SCAN): Menus 37, 38, and 39

Scan mode allows you to monitor several channels
more efficiently. Channels are scanned until activity is
detected on a channel. Depending on the scan mode,
scanning may continue after a specific length of time,
or it will only continue when the channel is inactive.
Scan Mode: Select the scan mode in Menu 38. There
are two modes:
Time operated (TO): Scanning stops when an
active channel is encountered. The scan will
pause for five seconds, then scanning will
continue, even if the channel is still active.
Carrier operated (CO): Scanning stops when an
active channel is encountered. Scanning resumes
after two seconds of channel inactivity.
The default setting is "TO".
37