Screens; Information Available During The Race; Race End; Deleting Race Data - Elite super crono Instructions For Use Manual

A F
B
C
D
E
1 ST SCREEN:
A Current Power
B Current Speed
C Grade
D Distance
E Race Time
F Indicator
AVAILABLE INFORMATION DURING THE RACE
Icon/Feature Screen Information
WATT 1 Current Power. Power expressed at the exact moment when the value is being read.
Km/h 1 Speed. Speed at the exact moment when the value is being read.
% 1 Grade. The grade seen is in function of the weight of the cyclist and the speed.
DST 1 and 2 Distance covered. Distance since the beginning of the training session.
TIME 1 and 2 Race Time. Time since beginning of the training session.
1,2 and 3 Indicator
AVG WATT 2 Average Power. Average power since the beginning of the training session.
AVG Km/h 2 Average speed. Average speed since the beginning of the training session.
% AVG 2 Average grade. Average grade of the session.
MAX WATT 3 Maximum Power. Maximum power developed during the training session.
MAX Km/h 3 Maximum speed. Maximum speed reached during the training session.
ELV.G 3 Elevation Gain. Indicates the difference of altitude gained during the training session.
ODO 3
Total Distance run. Odometer / Total Distance covered using the Super Crono Wireless.
TOTAL TIME 3 Total Time. Total Time using the Super Crono Wireless.
END OF THE TRAINING SESSION
At the end of the session it is possible to see the
maximum and average datas for power and speed,
the elevation gain and the overall time. If you start
pedaling again, the data will be updated as if part
of the same session.
At the end of training:
• For computers provided with a switch, switch
off the computer by turning it to "OFF".
• For computers without switch, disconnect the
cable M from the support. After 2 minutes the
computer will switch off automatically.
A
B
C
D
E
2 ND SCREEN:
A Average Power
B Average Speed
C Average Grade
D Distance
E Race Time
F Indicator
. Indicates if the current speed is higher ( ) or lower ( ) than the average speed.
After two minutes of inactivity, that is without
pedaling or pressing the console buttons, the
program goes into its standby mode. When this
happens, all the information for the session that
has just finished is memorized.
In case you want to start a new session and erase
the data, you just have to start the CLEAR proce-
dure.
To execute the CLEAR procedure you have to
press the SET button for at least 6 seconds.
F A
B
C
D
E
3 RD SCREEN:
A Maximum Power
B Maximum Speed
C Elevation Gain
D Total Distance
E Total Time
F Indicator
ERASING DATA
GB
F
29