Connecting to the Network
1.
Insert the 8-pin connector on the
RJ48S network cable into
the NET (network) interface.
PORT 1
COM
POWER
Connecting to a DTE
If the DTE cable type is EIA-232E:
1. Connect the EIA-232E end of the DTE cable to PORT 1 or PORT 2.
PORT 1
COM
POWER
If the DTE cable type is V.35 (one is provided, another can be ordered):
1. Connect the plug to the V.35 end of the adapter cable.
2. Connect the EIA-232E end of the adapter cable to PORT 1 or PORT 2.
Verification Checklist
Did the OK LED light? If not, see Troubleshooting in the User's Guide.
Did you set the async terminal or PC speed to 9.6 kbps so it matches the access
unit's factory-loaded speed, character length, and parity? If not, do so now.
Did the Main Menu appear on the terminal's screen? If not, see Troubleshooting in
the User's Guide.
Verifying connection to a LAN adapter, router, FRAD, or external modem requires setup
and configuration; see Setup in the User's Guide.
PORT 2
NET
BKP
PORT 2
NET
BKP
V.35 Adapter
Cable
4
2.
Insert the other end of the cable
into the RJ48S modular jack.
RJ48S
Jack
DTE
Cable
DTE
Cable
496-14941
Frame
Relay
Router
or
FRAD
Frame
Relay
DTE
496-14942