Install Smv Emblem (Semi-Mounted); Fill Gearboxes; Install Chain Shielding - Woods TS1680 Operator's Manual

Install SMV Emblem (Semi-Mounted)

See Figure 30.
1. Attach SMV socket (35) to deck bracket with two
carriage bolts (38) and lock nuts (39).
2. Attach SMV emblem (37) to SMV bracket (36)
using two round head cap screws (40) and hex
nuts (41).
3. Insert SMV bracket (36) and emblem (37) into
socket (35).
ALL MODELS

FILL GEARBOXES

NOTICE
■
Gearbox is not filled at the factory. Prior to
delivery to customer, make sure gearbox is filled
only half-full with 80W or 90W API GL-4 or GL-5
gear lube. Use side plug to remove any excess oil.
Side Gearboxes
1. Make sure vent plug hole is clear (installed by
dealer).
2. Remove plug on side of gearbox
3. Fill gearbox until oil runs out the side plug on
gearbox. Use a high quality gear oil with a viscosity
index of 80W or 90W and an API service rating of
GL-4 or GL-5.
4. Install side plug and vent plug.
Center Gearbox
1. Make sure dipstick vent hole is clear.
44 Assembly
Figure 31. TS1680 Chain Shielding Installation
2. Fill gearbox until oil level is between rings with
dipstick seated. Use a high quality gear oil with a
viscosity index of 80W or 90W and an API service
rating of GL-4 or GL-5.
3. Install dipstick.
INSTALL CHAIN SHIELDING (OPTIONAL)
 Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped when any-
one comes within 300 feet (92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
 Full chain shielding is required for all non-agri-
cultural mowing. Full shielding is also recom-
mended for all agricultural use to further reduce
the risk of thrown objects.
The chain shield assemblies are ready for installation
when you receive them.
Install front and rear chain shielding as shown using
carriage bolts (9) and lock nuts (10).
9. 3/8 NC x 1-1/4 Carriage bolt
10. 3/8 NC Flange lock nut
ANGER
MAN0577 (6/29/2007)