Brewing Single-Serve Packs - Hamilton Beach 49983A Read Before Use

How to Use Single-Serve Side –

Brewing Single-Serve Packs

w WARNING
Burn Hazard.
To avoid contact with hot coffee or water:
• Do not use more than 10 oz. (300 ml) of water for a single-serve pack. Adding too much water to the water reservoir will cause an error
message to appear in the display, along with a long beep. Place carafe on warming plate. Turn brew selector dial to Carafe (
BREW NOW button to remove water. Wait for 3 beeps and blue power light to turn off. Restart the Single-Serve process.
• Fill reservoir with cup or travel mug of water into which the coffee will be brewed.
• Fully insert cup or travel mug under brew basket.
• For best results, use K-Cup
NOTES:
• The unit will only brew on one
side at a time.
• For Hotter Coffee: Rinse the
mug with hot water before
brewing.
• The Brew Mode selection will
stay in the last mode used,
unless unplugged.
• Coffee may continue to drip
after brewing is complete (after
3 beeps) when using finely
ground coffee.
• Programming mode cannot be
used on Single-Serve side.
840219701 ENv04.indd 5
* packs.
®
1
Plug in coffeemaker. Rotate brew
selector dial to the right to select
Single-Serve ( ). Press BREW
OPTIONS button to select
*K-Cup is a registered trademark of Keurig, Inc. Use of the K-Cup trademark does not imply any affiliation with or
endorsement by Keurig, Inc.
2
Remove brew basket. Place a
pack into the single-serve pack
holder.
.
CAUTION! Cut Hazard: Single-
serve pack holder has a sharp
blade. Handle with care.
) and push
3
Press down on edge of the pack
until the pack snaps into place and
hole is punched in the bottom. Do
not remove foil.
1/29/14 4:46 PM
5