Audiovox Dvd3100 Instructions Manual

Audiovox operating instructions in-dash dvd player dvd3100

Advertisement

Quick Links

In-Dash Single Disc
DVD/CD Player
Before operating the unit, please read these
instructions carefully
128-5987

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox Dvd3100

  • Page 1 In-Dash Single Disc DVD/CD Player Before operating the unit, please read these instructions carefully 128-5987...
  • Page 2: Important Notes

    Welcome Thank you for purchasing this DVD/CD player. Before operating the unit, please read this manual thoroughly and retain it for future reference. IMPORTANT NOTES To prevent an electrical system short which could cause serious damage to the unit, the vehicle, or cause personal injury, please follow the safety recommendations below: Should there be requirement to replace a blown fuse, remember to first disconnect all power and switch off the unit before fuse replacement.
  • Page 3 Depending on reception quality of the TV, noise interference may appear while a broadcast is being received with the DVD powered on. This is not a malfunction of the DVD or the TV. To watch a TV broadcast, turn off the DVD. To prevent an operational malfunction, do not play discs other than DVD audio discs, DVD-ROMs, CD-ROMs, Photo CDs and DVDs with region numbers other than this player’s region number.
  • Page 4: Installation Guide

    INSTALLATION GUIDE Precautions: 1. This DVD/CD player should be install by qualified technician or service personnel. 2. The DVD/CD is designed to operate with a 12 Vdc, negative ground battery system. 3. Disconnect the ground wire from the battery terminal before connecting the unit to the electrical system.
  • Page 5: Back Panel

    Back Panel The figure below shows the back panel design for the player. It also indicates the wire definition for interconnections. Control Unit Interface Audio Output : Audio R White : Audio L Yellow 3 pin Con : Video Output Optical Connector : Rear IR Operating Instructions...
  • Page 6: Remote Control Reference Guide

    2.1 Remote Control Reference Guide Power Button Setup Button Display Button Up Cursor Key Left Cursor Key Enter Key Previous/Reverse Skip Button Down Cursor Key Reverse Scan Button 10. Play/Pause Button 11. Subtitle On/Off Button 12. Subtitle Selection Button Numeric Buttons 14.
  • Page 7: Title Button

    2.2 Front Panel Control Reference Guide QHFYR[ RETURN STOP MUTE AUDIO 17 16 15 14 1. Power Indicator 2. Disc slot 3. Remote Sensor 4. Eject Button 5. Cursor Right Key 6. Cursor Up Key 7. Enter Key 8. Cursor Down Key 9.
  • Page 8: Basic Functions

    3. Basic Functions 3.1 DVD Playback (DVD) 1) Press the POWER( ) button on the remote control, or the DVD/CD player front panel POWER ) button to switch on unit power. 2) Insert a disc into the unit. 3) DVD playback commences: The disc will start to play if the disc does not have any menu recorded on it.
  • Page 9 3.2.2 Playback Video CDs with Playback Control Without Using Menus (VCD) 1) Press the MENU/PBC button to set PCB off. 2) “PBC OFF” will be displayed on the TV screen. 3) Press the required track number button to select the preferred track, or press the PLAY/PAUSE ( ) button to commence playback.
  • Page 10 3.4 Next track or previous track (CD/VCD/DVD) Press during playback. Audio CD and Video CD: The player will skip forward to the next track each time the button is pressed. “SKIP FW” will be displayed on the TV screen. DVD: The player will skip forward to the next title/chapter each time the button is pressed.
  • Page 11 3.8 Search Function (CD/VCD/DVD) The Search function enables you to pinpoint a specific location by entering the time/track/chapter or title. Audio CD: When the SEARCH button is pressed the following will be displayed: TRACK xx Use the numeric keys to enter the desired track or disc time; pressing the ENTER button will cause the player to start playing at the selected track or time.
  • Page 12: Repeat All

    DVD: When the SEARCH button is pressed the following will be displayed: TITLE xx Use the numeric keys to enter the desired title or chapter, or chapter time; pressing the ENTER button will cause the player to start playing at the selected title, chapter or chapter time. If you are not in search mode, you may use the numeric keys to enter the desired chapter;...
  • Page 13 For DVD: When the REPEAT button is pressed: RPT CHAPT RPT CHAPT The current chapter will be repeated RPT TITLE The current title will be repeated REPEAT OFF Repeat mode will be switched off 3.9.2 Camera Angle (DVD) Some DVD discs may contain scenes which have more than one viewing angle. For these discs, the same scene can be viewed from a different angle by using the ANGLE button as follows: NOTE: This function will only operate on discs where different camera angles have been...
  • Page 14: Subtitle (Dvd)

    3.9.4 Subtitle (DVD) During DVD playback, you may change the subtitle language from the one selected at the initial setting to a different language, if available. 1) When the SUBTITLE ON/OFF button is pressed: SUBTITLE ON 2) During DVD playback with SUBTITLE ON, press the SUBTITLE button . “SUBTITLE x/y”...
  • Page 15 3.9.7 Display Function (CD/VCD/DVD) The display function enables you to view the status, current title number, track number and the total playing time of the disc on the TV screen. Audio CD: When the DISPLAY key is pressed, the following OSD will be shown: TRACK 1/15 TTIME...
  • Page 16 DVD: When the display key is pressed, the following OSD will be shown: TITLE CHAPTER 1/20 CTIME 02:14:21 ANGLE SUBTITLE AUDIO No display CTIME = Chapter time CRTIME = Chapter remaining time TTIME = Title time TRTIME = Title remaining time 3.9.8 Setup Menu (DVD) When the player is in stop mode, pressing the SETUP button will allow you to modify some of the player’s basic settings.
  • Page 17: Disc Language

    (1) Disc Language a) During STOP, press the SETUP button; the setup menu will appear. b) Use the buttons or numeric key to select the DISC LANGUAGE item; then press the ENTER button. The disc language menu will appear as follows: DISC LANGUAGE (1) AUDIO (2) SUBTITLE...
  • Page 18 (2) Password NOTE: The factory default password is 1234 a) During STOP, press the SETUP button, the setup menu will appear. b) Use the buttons or numeric key to select the PASSWORD item, then press the ENTER button. The change password menu will appear. CHANGE PASSWORD PARENTAL PASSWORD...
  • Page 19 (3) Parental Control a) During STOP, press the SETUP button, the setup menu will appear. b) Use the buttons or numeric key to select the PARENTAL item; then press ENTER. The DVD/CD player will request a parental password. PARENTAL PASSWORD PASSWORD c) Use the numeric keys to enter the password;...
  • Page 20: Digital Audio Out

    (5) Digital Out a) During STOP, press SETUP button, the setup menu will appear. b) Use the buttons or numeric key to select the DIGITAL OUT item, then press ENTER. The preferred digital audio output will be shown as follows: DIGITAL AUDIO OUT (1) LPCM (2) DOLBY DIGITAL...
  • Page 21: Product Specification

    4. Product Specification GENERAL Power Supply Current Consumption Operating Positions Dimension (WxHxD) Inches (Millimeters) Weight AUDIO Output Frequency Response Distortion Dynamic Range S/N Ratio Cross Talk Optical Output VIDEO Television System Playback Disc Aspect Ratio TV Encoder Resolution Video S/N CONNECTORS Output Audio Video Output...
  • Page 22: Region Management Information

    5. Region Management Information This DVD/CD player is designed and manufactured to respond to the Region Management Information that is recorded on a DVD disc. If the Region number described on the DVD disc does not correspond to the Region number of this player, this player will not be able to play the DVD disc.

This manual is also suitable for:

1285987

Table of Contents