Galileo Quark SoC X1000 Getting Started Manual page 12

the USB Client port.
Step 2: Set Up the Arduino Galileo IDE
Open up the Galileo-specific Arduino software you downloaded earlier. Mac users can double-click
the application file, Windows users should run the Arduino.exe file at the top level of the unzipped
folder.
Serial Port Selection
Double-check that the title of the Window has Arduino 1.5.3 at the top. Then the first step is to select
the serial port. Go to the Tools menu, then hover over Serial Port. On a Windows machine, select
the COM port you saw earlier in the Device Manager. On a Mac machine, select the
/dev/cu.usbmodemXXXX (make sure it's the cu option) that matched what you found in the System
Information panel.
Board Selection
Under the Tools > Board menu, make sure Intel ® Galileo is selected. (Not that you have any other
choice.)
Step 3: Firmware Update
Page 12 of 20