Galileo Quark SoC X1000 Getting Started Manual page 10

7. Click Install on the next Windows Security window that pops up. And, after a number of
loading-bar-scrolls, the installation should complete and you should be greeted with a
Windows has successfully updated your driver software window.
8. Look back at the Device Manager, under the Ports tree now. There should be an entry for
Galileo (COM #). Remember which COM # your Galileo is assigned, it'll be important for
Arduino sketch uploading and the next step,
Mac OS X Driver Install
Mac has built-in driver support for the Galileo, so this setup should be easy. Follow the steps below
to install the board on your machine:
1. Begin by connecting 5V power to the Galileo.
2. Then connect a
USB socket on your computer.
3. Wait a few seconds while the Galileo boots up. To verify the Galileo has enumerated properly,
open the System Information window (Hold Option > Click the Apple menu in the top left >
Click System Information), and check under the USB tab for a Gadget Serial v2.4 entry.
from the USB Client port on the Galileo to an available
micro-B USB cable
updating firmware.
Page 10 of 20