Air Filter - Sharp TE-T56U Operation Manual

C A R E A N D C L E A N I N G

Air Filter

Monthly Maintenance
Remove the air filter panel from the back of the main unit. Wash in warm or cold water, and wipe
dry. Reinstall on the main unit immediately.
Descaling
After frequent use, mineral content from water may build up in the pipe or other parts
of the appliance. This is called "scale". If scale becomes an issue, water will begin
taking longer to boil or remain in the water reservoir. Remove any scale build-up with
the following method:
1. Fill the water reservoir to the MAX mark with fresh cold
water. Do not fill past the MAX mark.
2. Dissolve 1 tablespoon of pure citric acid crystals in the
water. Stir well. Set the lid and insert into the main unit.
3. Insert the empty container into the main unit. Plug in.
4. Press the MODE button once, and then press the
START button.
5. When 4 beeps sound, remove the container and discard
the hot water.
6. Fill the water reservoir to the MAX mark with fresh cold
water, and set the lid. Insert the water reservoir into the
main unit.
7. Insert the empty container into the main unit.
8. Press the MODE button once, and then press the START button.
9. When 4 beeps sound, remove the container and discard
the hot water.
10. Repeat steps 6 to 9 two or three times. After use, disconnect
the plug from the outlet.
WARNING:
The container and its lid will become hot. To PREVENT BURNS,
remove while using potholders.
NOTES:
1. Frequency of descaling will vary depending on the hardness of the water. If you use hard water
(high in mineral content), regular descaling is recommended.
2. Pure citric acid is available at numerous drugstores.
Removal
Tab
Push the tab to
the right.
E-20
Installation
Slits
Tabs
Insert the 2 tabs of the air filter
panel into the corresponding slits
on main unit. Press the air filter
until it snaps into place.
(Boiling time : Approx. 5 min)