Silvercrest swv 300 b2 User Manual page 168

SilverCrest SWV 300 B2
Insert the dual-band wifi range extender into a socket that is always easily
accessible.
Then switch on the dual-band wifi range extender by turning the main switch
(9) to the "ON" position. The dual-band wifi range extender requires a certain
amount of time (boot time) after it is switched on before it is ready to use. The
Power/WPS LED (3) lights up permanently as soon as the booting process is
complete.
There are two different ways to configure the dual-band wifi range extender.
If you are not using the network default settings and have
manually set an IP address, you must restore the network
settings to Obtain an IP address automatically. For
further details, please read the operating instructions for your
computer.
If the dual-band wifi range extender was previously used in
another network, it might not be accessible any longer at the
default address. In this case, the dual-band wifi range extender
must be reset. See the second point for "The configuration menu
166 - English