Setting Up Adnet 2000™ For The T-Max® Intercom System; T-Max ® Intercom System - Salon Systems T-Max Manager User Manual

1) Click Manager Utilities then Auto Address the T-Max® System with your left mouse
button.
2) A window will appear with the following message: Proceed with Auto Address of Entire
System? (Make sure there are no active sessions).
3) Click OK with your left mouse button of you want to proceed. Click Cancel of you do not
want to auto address the salon.
Once you click OK, the Manager Access screen will disappear and the ADNET 2000™
screen will appear. Each timer in the salon will show a 99 and be sounding an alarm. The
T-Max® Manager/Plus LCD display will show Auto Addressing Bed 00. Go to each
timer in order that you want the salon to be and press the Start/Stop buttons along the
way. Each timer will go to a 0. Make sure you press the Start/Stop buttons in order that
you want the salon addressed. Go to room 1 first, then room 2, room 3 etc.
The T-Max® Mgr/Plus LCD display will show Auto Addressing Bed XXX. XXX will be
one number higher then the number of beds addressed. Press the Enter button on the T-
Max® Manager/Plus keypad.
4) On your computer, press the Start button with your left mouse button. The Manager Access
screen will reappear with the new configuration being displayed.
6.4 Setting Up ADNET 2000™ for the T-Max® Intercom System
ADNET 2000™ can be used to send automated messages to each timer while the timer is in
Delay, while the Clean Room indication is showing or when the timer is in cool down mode.
You must have a sound card and microphone to use this feature.
T-Max® Manager/Plus and T-Max®3A/F/I User's Guide Page 23