Pausinga Session; Cancelinga Session; Clean Room; Computer Operation - Salon Systems T-Max Manager User Manual

corner on the T-Max® Mgr and T-Max® 3A displays. Once the Session starts, the session
time will be displayed on the T-Max® Mgr and the T-Max® 3A. The flashing light will slow
to a once per second rate.
If the Auto Start Mode is set to a 2 (Infinite Delay), the displays on the T-Max® 3A and the
T-Max® Manager will show the session time with a fast flashing period on the lower right
corner. The customer must press the Start/Stop button on the T-Max® 3A to start the session.
The Delay will be ignored.
5.4 Pausing A Session
Press the Start/Stop button on the T-Max® 3A. The flashing period on the T-Max® 3A and the T-
Max® Mgr will stop flashing and stay illuminated. The session time will continue to count and
the display on the T-Max® 3A and the T-Max® Mgr will continue to reflect the remaining
session time. To restart the session, press the Start/Stop button and the period will continue
flashing.
5.5 Canceling A Session
To cancel a session, press the Start/Stop and Set buttons on the T-Max® Mgr under that rooms
display at the same time.
If the session was canceled while the T-Max® 3A was still in Delay, the clean room
indication will not appear. If the Clean Room Indication is enabled on the T-Max® 3A and
session was canceled after the tanning bed has been energized, the clean room indication will
appear on the T-Max® 3A and the T-Max® Mgr.
5.6

Clean Room

Once the session time has elapsed, the display will show two periods with no numbers which
is an indication that the room needs to be cleaned. For a complete description of Clean
Room, refer to Section 11.1.
6

COMPUTER OPERATION

6.1

Installing ADNET 2000™

1) Place the ADNET 2000™ diskette in drive A.
T-Max® Manager and T-Max® 1A User's Guide Page 12