Getting And Changing Parameters - Salon Systems T-Max Manager User Manual

6.3.5

Getting and Changing Parameters

1) Click Bed Parameter Utilities with your left mouse button.
2) Click Upload Parameter from Beds. The Timer Parameter Access screen will appear:
Timer Parameter Access Window
3) To change a parameter, move the mouse to the window beside Password and click it with
your left mouse button. A flashing cursor will appear in the window. Enter the password (see
the attached password sheet provided with this manual). As you enter the password, an (*) will
appear for each character.
After the password has been entered, place the mouse in the window where you want to
change the parameter. For example, if you want to change parameter 5 for bed 2, place
the mouse in the white window below Param 5 and beside 2 as the arrow shows in the
Timer Parameter Access window.
4) Click the left mouse button.
5) A Change Parameter Data window will appear. Enter the value you want to change the
parameter to then click OK with your left mouse button. If you don't want to change the
parameter value, click Cancel.
6) The change parameter window will change the show the new value for that parameter.
7) When you are done changing parameters, click Close with your left mouse button.
T-Max® Manager/Plus and T-Max®3A/F/I User's Guide Page 20