Philips S9531 Quick Start Manual page 17

ENGLISH
30
C
Q During the drying phase, the drying symbol
blinks.
Q The drying phase takes approximately 4 hours.
When completed, the drying symbol will light
up continuously.
Q Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur, the
cleaning cycle will stop and the cleaning or
drying symbol goes off . The cleaning cycle can
be re-started by pressing the ON/OFF button
once.
Q If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
C
NOTE: When the cleaning cartridge filter is full,
the replacement symbol blinks orange. (See
'Replacing the SmartClean System Cartridge').
C
9 When the entire cleaning cycle is complete
and the shaver is hygienically clean, the
ready symbol lights up continuously.
The battery symbol on the shaver will light up to
indicate the shaver is fully charged.
C
10 Press the top cap (1), pull the shaver
1
3
forward (2) and lift shaver from
2
SmartClean holder (3).
Q The SmartClean System automatically turns
off 30 minutes after the cleaning and drying
phases are complete.
C
11 Place the shaver in the SmartClean System
to protect shaver heads.
Cleaning the Trimmer
Clean the trimmer after each use.
C
1 Attach the trimmer to shaver.
2 Turn shaver ON.
C
3 Rinse the trimmer under hot water. BUT
BE CAREFUL TO TEST WATER FIRST SO
AS NOT TO BURN OR SCALD HANDS.
4 Turn shaver off. Shake off excess water and
allow trimmer to air dry thoroughly.
Tip: For optimal trimmer performance, lubricate
the trimmer teeth with one drop of mineral
oil every 6 months.
ENGLISH
31