Table of Contents
Advertisement
Instructions for connecting to mains power:
1. Make sure that the switch (1) is in the off position. The machine must be switched off before
connecting up to the mains power.
2. The main lifting lever for the sanding drum (2) must be moved backward so that the sanding
drum is raised from the floor.
3. Hang the swivelling cable arm (3) into the left or right cable arm bracket as required.
Wind the mains cable through the curl at the end of the cable arm (3) to keep the cable
away from the sanding zone.
4. Connect the coupling (4) of the mains cable to the motor plug, which must be
disconnected from mains power.
5. Connect the plug of the mains cable via a portable RCD (Residual Current Protective
Device) to an adequately fused and earthed 230 V mains socket.
Caution!
Never switch the motor on if the sanding belt is not tightened.
Caution!
Never switch the motor on if the sanding drum is not raised from the floor.
Caution!
Risk of injuries from the machine starting up unintentionally! Disconnect the machine
from the power supply when not in use, when changing the sanding belt and when
carrying out any other work to the machine.
21
05/2011
Advertisement
Table of Contents
