Replacing The Sanding Belt - Pallmann KING COBRA Operating Instructions Manual

7.5

Replacing the sanding belt

Caution! Danger from machine starting up!
When replacing the sanding belt, there is a risk from the machine starting up
unintentionally. Always disconnect the parquet floor sander from the mains power before
working at the sanding belt.
Caution! Risk of cutting your hands!
The sanding grains of the sanding belt have sharp edges. Always wear safety gloves
when replacing the sanding belt.
Instructions for replacing the sanding belt:
1. Switch the machine off.
2. Disconnect the machine from the mains
power.
3. Open the sanding drum cover (1).
4. Move the tension lever (2) forward. The
sanding belt which was held under tension
is now released. Pull it out to the side.
5. Insert a new sanding belt.
6. Clamp the new sanding belt by moving the
tension lever (2) backward.
7. Close the sanding drum cover (1).
18 05/2011