BGH BSBSIC24CTK Manual page 69

Controller
10. FAN SPEED Button: This button is used for setting fan speed in the sequence that goes from AUTO,
LOW, MED to HIGH, and then back to Auto.
11. TEMP UP Button: Push this button to increase the indoor temperature setting or to adjust the timer in a
counter-clockwise direction.
12. VENT Button: Push this button to set the ventilating mode. The ventilating mode will operate in the
following sequence:
1.3 KJR-10B (Optional)
Name and functions of buttons on the wire controller
1 mode selection button:
It is used to select mode, push the button one time, then the operation modes will change
In turn as follows:
Remark: no heating mode if wire controller is set as the cool only.
2 Timer on button:
Push the button to set TIMER ON, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER ON, then adjust the time of TIMER ON as 0.0
3 Timer off button:
Push the button to set TIMER OFF, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER OFF, then adjust the time of TIMER OFF as 0.0
4 CLOCK button:
65
AUTO COOL DRY FAN
HEAT
Control