Special Product Features; Initial Operation - Metabo BDE 1100 Original Instructions Manual

en ENGLISH
6 Rotation selector switch
7 Side handle

6. Special Product Features

Metabo S-automatic safety clutch:
If the insertion tool jams or hooks, the power flow to
the engine will be restricted. Because of the high
power which then arises, always hold the machine
with both hands on the handles, stand safely, and
concentrate on your work.

7. Initial Operation

Before plugging in check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply
Always install an RCD with a maximum trip
current of 30 mA upstream.
Australia: Always use a residual current
device (RCD) protected supply with a
rated residual current of 30 mA or less.
8. Use
8.1 Depth Stop Setting
Loosen the side handle (7). Set depth stop (1) to the
desired drilling depth and retighten the side handle.
8.2 Switching On and Off
To start the machine, press the trigger (5).
The speed can be changed at the trigger.
Thanks to the electronic soft start the machine
accelerates continuously up to maximum speed.
For continuous operation the trigger can be locked
with the lock button (4). To stop the machine, press
the trigger again.
If switched on continuously, the machine
continues running if it is jerked out of your
hands. Therefore, always hold the machine
with both hands on the handles, stand safely,
and concentrate on your work.
8.3 Speed selection
Select the desired speed by turning the thumb-
wheel (3).
Change speed only when the machine is in the
process of running down (briefly switch it on
and off).
1st speed
(low speed, high torque) e.g. for
screwdriving, drilling
2nd speed
(high speed) e.g. for drilling
8
8.4 Selection of rotary direction
Do not actuate the rotation selector switch
(6) unless the motor has completely
stopped.
Selecting the direction of rotation:
clockwise
counter-clockwise
8.5 Tool change with a geared chuck (2)
x 3
Chucking the tool:
Insert the tool and use the chuck key to uniformly
clamp tight all 3 bores.
Removing the tool:
Open the geared chuck with the chuck key and
remove the tool.
8.6 Remove the handle.
To be able to remove the handle you must first of all
remove the chuck.
8.7 Removing the chuck
Geared chuck (2)
Undo the locking screw. Caution left-handed thread
!
Hold the drill spindle tight with a spanner. With a
light blow from a rubber hammer release the chuck
from the inserted chuck key and unscrew it.