Valid Dial Command Modifiers - Paradyne 392xPLUS Installation And Operation Manual

COMSPHERE 392xPlus Modems
Dial command modifiers are parameters entered in the dial command string which specify how, when, and what number
to dial. The following is a list of parameters the 392x Plus modems recognize:
T — Tone (DTMF) dial. Any digit 0–9, *, or # can be dialed as tone.
P — Pulse dial. Only the digits 0–9 can be dialed in Pulse Dial mode.
NOTE: Once a dialing method (tone or pulse) has been specified, it will only remain active until the end of that dial
string. The modem defaults to the value set by the Dialer Type configuration option.
, — Pause. Causes the modem to pause before processing the next character in the dial string. The length of
this pause is determined by the setting of the Pause Time configuration option (refer to the Line Dialer
configuration option group) or by the value held in S-Register S8.
W — Wait for tone dial. The modem waits for a second dial tone before processing the dial string. This can be the
initial dial tone or can be used when dialing through a tandem PBX.
R — Reverse Dial mode. Causes the originating modem to send out an answertone once it no longer detects
ringback. (Ringback is the ring you hear at the originating site when making a call.) The R modifier must be
the last character in the dial string.
@ — Quiet answer. Wait for five seconds of silence after dialing the number. If the silence is not detected, the
modem sends the NO ANSWER result code to the DTE or displays the No Quiet Answer LCD status
message.
! — Hook flash. Causes the modem to go on-hook for 0.5 seconds then return to off-hook.
; — Return to Command mode. Causes the modem to return to Command mode after dialing a number without
disconnecting the call.
Space — Ignored by the dial string, can be included to enhance readability.
– — Ignored by the dial string, can be included to enhance readability.
+ — Ignored by the dial string, can be included to enhance readability.
( ) — Ignored by the dial string, can be included to enhance readability.
— End of Number. Hides all characters appearing on the LCD entered to the right of this indicator.
Directory Status (may not appear for certain countries)
Directory Status displays the status of each directory location.
To access Directory Status from the Call Setup branch, make the following selections:
Press the
Directory_Status.
Press the
Directory_Status.
3-72
Table 3-9

Valid Dial Command Modifiers

key until Directory_Status appears. Press any function key to select
Call Setup: <
Directory_Status
F1 F2 F3
key until Directory_Status appears. Press any function key to select
November 1996 3920-A2-GN31-30