Paradyne 392xPLUS Installation And Operation Manual page 247

Sync Leased
Configuration
Default
Option
Settings
V.42 / MNP / Buffer ††
Error Control Mode Direct
V.42bis Enable
Compression
MNP5 Enable
Compression
EC Negotiate Disable
Buffer
EC Fallback 013
Character
Flow Control of CTS to DTE
DTE
Flow Control of RTS to Modem
Modem
XON/XOFF Disable
Passthrough
Modem to Modem Disable
Flow Control
Break Buffer Keep Data
Control
Send Break Data First
Control
Buffer Disconnect 10 sec
Delay
Maximum Frame 256
Size
Cellular Disable
Enhancement
Reduced Async Disable
Buffer Size
†† Not applicable when Async/Sync mode is set to Sync.
Refer to Chapter 4, DCP Configuration , for additional information.
Not applicable when MUX Mode is enabled.
3920-A2-GN31-30
Table F-1
(8 of 10)
Factory Default Configuration Options
Async Leased TMp
Default Default
Settings Settings
Direct Direct
Enable Enable
Enable Enable
Disable Disable
013 013
CTS to DTE CTS to DTE
RTS to Modem RTS to Modem
Disable Disable
Disable Disable
Keep Data Keep Data
Data First Data First
10 sec 10 sec
256 256
Disable Disable
Disable Disable
November 1996
Default Configuration Options
Async Dial UNIX Dial
Default Default
Settings Settings
V.42/MNP/Buffer V.42/MNP/Buffer
Enable Enable
Enable Enable
Disable Disable
013 013
CTS to DTE CTS to DTE
RTS to Modem RTS to Modem
Disable Disable
Disable Disable
Keep Data Keep Data
Data First Data First
10 sec 10 sec
256 256
Disable Disable
Disable Disable
Sync Dial
Default
Settings
Direct
Enable
Enable
Disable
013
CTS to DTE
RTS to Modem
Disable
Disable
Keep Data
Data First
10 sec
256
Disable
Disable
F-9