ACARD AEC-6280
4.1.4 Windows XP Environment
Driver installation is required when it is the first time to set up Windows XP
on the computer.
Boot Device
AEC6280.SYS is designed for Microsoft Windows 2000 miniport drivers. It
allows a driver to be connected to an IDE device supported by Microsoft.
1. Insert the Windows XP boot disk and boot from the floppy disk.
(If you boot from CD-ROM or hard disk, please press "F6" on the first
booting screen.)
2. Follow the Windows XP setup procedures.
3. Press "S" to specify additional SCSI adapter.
4. Move the highlight bar to "the other" and press "Enter".
5. Before installation, copy the AEC-6280's driver into a floppy disk.Then
insert the ACARD AEC-6280 driver disk into drive A. Refer to Appendix 2.
6. The ACARD miniport driver should be highlighted at this stage. Press
"Enter" to proceed.
7. Windows XP will now recognize the ACARD miniport driver and the IDE
hardware. Please follow the Microsoft Windows XP installation.
Install the Driver for Windows XP
After installing Windows XP, you can set up the ACARD AEC-6280 device
in the operating system. Follow the procedures below to install the ACARD
AEC-6280 driver manually.
28