Chapter 4 System Installation; Dos Environment - Acard AEC-6280 User Manual

ACARD AEC-6280

Chapter 4 System Installation

4.1 DOS Environment

Boot Device
1. Complete ACARD AEC-6280 hardware installation.
2. Boot up the computer. Press <Del> to enter the motherboard's BIOS
setup. Then change "Boot Sequence" to A:.
3. Restart the computer by a DOS bootable floppy and run DOS FDISK.
Then create a Primary partition onto the hard drive.
4. After restarting the DOS bootable floppy, run the DOS FORMAT
command.
None Boot Device
1. Complete ACARD AEC-6280 hardware installation.
2. Boot up the computer. Press <Del> to enter the motherboard's BIOS
setup. Then change "Boot Sequence" to C:.
3. Restart the computer, and run MS-DOS and DOS FDISK. Then create
a Primary partition onto the hard drive.
4. After restarting, run the DOS FORMAT command.
15