Menu Lock - Bush DVB-T2 PVR User Manual

Output Settings
TV Type
• Digital terrestrial television channels can be
broadcast in a widescreen format which must be
output differently to normal and widescreen TV sets.
• This function defines the screen format of the
connected TV to enable broadcasts' being displayed
correctly.
• Select 4:3 if you have a standard TV set with 4:3
aspect ratio.
• Select 16:9 if you have a widescreen TV.
Note: This function also enables you to change the
TV Type that you have previously selected during the
first time installation.
TV Out
• The set top box can output RGB and CVBS signal via
the TV SCART connector located on the rear panel.
• Some devices might not support the RGB format.
Receiver Upgrade
• To ensure that your set top box always has the most
up to date information, you can use this setting. In
order for the proper operation, please ensure that
the box is set to standby mode.
• The STB automatically powers up at 3.00 A.M. every
day and searches for any new software that may
be broadcast. If found, the box will download new
software automatically. This operation will normally
take approximately 30 minutes.
• You can enable or disable automatic upgrade by
setting Automatic Scanning option.
• You can manually search for new software by
selecting Scan for upgrade.
• You can also update your set top box by using the
USB upgrade option.
Parental Settings
• This setting configures menu locking.
• Select Menu Locking option by using " "/" " buttons.
• Press OK button to enter the menu.
• To display parental lock menu options, PIN number
should be entered. Factory default PIN number is 0000.
After coding the correct PIN number, parental settings
menu will be displayed:
Set Pin
• Press OK to display the "Set PIN" window. Use
numeric buttons to enter the new pin number. You
will need to input your new pin a second time for
verification purposes.
• The factory default pin number is 0000. If you
change the pin number make sure you write it down
and keep it safe.

Menu Lock

• Menu lock setting enables or disables the menu
access. You can disable access to the installation
menu or the whole menu system.
Guidance
Guidance setting enables or disables the menu
access.
Low Power
If you enable low power option, low power mode will be
activated. In low power mode the power consumption
is less then 0.5W (in standby). If you disable low power
option the power consumption will be high in standby
mode .However the opening time will be shorter and
aerial RF loop_through is operative in stand-by when
the "Low Power" is set to "NO".
Auto Standby
• Press " " or " " button to select Auto Sleep.
Use " " or " " button to set the Auto Sleep to
Disabled, 2 Hours, 4 Hours, 6 Hours or 8 Hours.
• After the timeout value is reached, the box will
switch off.
- 20 -