ParaBody Leg Press 100101 Assembly Instructions Manual page 5

I
/
/
FIGURE 2
STEP 2:
¯ Insert two 2" SQ. ENDCAPS (13) into file ends of the SEAT FRAME (2) as shown in FIGURE
¯ SECURELY
assemble one 3/8" SPRING PIN (33) to the spring pin barrel on the SEAT FRAME (2) as shown in FIGURE
¯ Attach four PARAGLIDE
STRIPS (14) to the inside of the SEAT FRA~£E (2) using file following steps:
¯
Thoroughly clean all surfaces where the PARAGLIDE STRIPS (14) are to be attached.
¯
l~emove the PARAGLIDE STRIPS (14) from the paper backing and firmly apply them to all shown surfaces.
5